Blocks 63.8% of IR Infrared Rays
Combines Heat Insulation and Protection

Unmatched Scratch Resistance

We conducted a simulation test during the sandstorm season, using genuine wiper blades from automotive manufacturers to test scratch resistance after 10,000 cycles of movement in yellow sand.
The test results are as follows:

Superior Impact Resistance

The gravel impact test, also known as the Grava test, uses an air pressure machine to ensure the gravel diameter is about 10 mm. Gravel with a particle size of 3.2-4.8 mm is sprayed at the glass surface from a 35-degree angle at a distance of 1 meter (impact speed approximately 80 km/h)

Comparison Results Are Significantly Different

• The glass surface protected by Solid Shield shows no visible scratches and remains nearly intact
• The glass surface not protected by Solid Shield shows numerous pits and dents from gravel impact

Outstanding Outdoor Durability
Meets Double 85/1000 Hours Automotive Grade Testing Standards

Using QUV (Ultraviolet Accelerated Weathering Tester) for accelerated durability testing, the results show that Solid Shield has impressive weather resistance. After testing for 1000 hours in an environment of 85°C high temperature and 85% humidity, there were no obvious cracking, peeling, discoloration, or fading.

The UVB-313 lamp used for the test does not reach the short-wave ultraviolet rays present in sunlight, maximizing the acceleration of aging. (Test standards comply with JISD0205 Japanese Automotive Grade Component Weathering Test Standards)

Long-lasting Superhydrophobicity

The water contact angle is 108 degrees. After SWOM (Simulated Weather Resistance Test) for 300 hours, the contact angle remains at 102 degrees with no significant change.

Installation Showcases

Heat Insulation and Hydrophobicity Test

Steel Ball Impact Test, Speed:130km/h, Distance: 5 meters

Solid Shield Installation Video

Product Quality Assurance Terms

Dear Solid Shield Windshield film users, thank you for choosing our Solid Shield Windshield film. To protect the product quality and safety of Windshield films, and to ensure the product’s environmental protection, health, and safety during use, Solid Shield Windshield film is produced in Japan using precise and meticulous processes. To ensure your rights and interests, please carefully read the following quality assurance terms.

1. Solid Shield Windshield Film have been tested and certified by Japanese authorities and have passed international quality standards. Solid Shield products are genuine and safe.

2. This quality assurance applies only to users of Solid Shield Windshield film. If you did not purchase Solid Shield Windshield film from an official authorized dealer or if the product was damaged due to improper use or maintenance, the company reserves the right to refuse the warranty service.

3. If the Solid Shield Windshield film has defects in material or workmanship within the warranty period, and the product was installed and used under normal conditions, the company will replace or repair the defective product for free. However, the company does not provide compensation for additional losses caused by product issues, such as vehicle damage or personal injury.

4. This quality assurance does not cover any damage caused by accidents, improper use, negligence, or unauthorized repairs. It also does not cover normal wear and tear, discoloration, or fading of the film.

5. Please contact our authorized dealers for any warranty service. For quality assurance service, please contact the Solid Shield customer service hotline at 6018- 660 9000

Daily Maintenance Tips

How to Extend the Lifespan of Solid Shield Windshield Film?
The lifespan of Solid Shield Windshield Film depends on the cleanliness of the wipers and the car’s windshield. Solid Shield Windshield Film are consumables with characteristics similar to tires, brake pads, and wipers. Different variables in usage management will affect the specific use cases. Regular maintenance can conveniently ensure stable quality and extend the product’s lifespan. Conversely, neglecting daily maintenance will cause risk factors that affect the lifespan.

1. Regular Replacement and Maintenance of Wipers.
2. Avoid exposing the vehicle to high temperatures, sand, dust, heavy rain, and other harsh weather conditions. 3. Regularly clean the car’s windshield with mild detergent and water to ensure it is clean.
4. Advisable to park the car at roofed parking space.

Regular Replacement and Maintenance of Wipers.
Wipers should be maintained or regularly replaced once a month or every 5000 kilometers to avoid damage and wear to the Solid Shield Windshield film’s surface rain-repellent hydrophobic coating, which will affect the product’s lifespan.
Common Wiper Issues: Dirt, Aging & dust.
1. Fixed replacement every 5000 kilometers.
2. Preventive maintenance should be performed once a month or every 5000 kilometers
3. Wiper maintenance: Spray WD-40 onto a clean dry cloth and wipe the wiper for 1 minute to clean off the dirt.